Installation
|
Wall Installation Instructions:
Attach to a wall using the hardware provided. Cart Installation Instructions: Strap or bolt securely to cart using the mount openings on the unit using cable ties or heavy duty strapping/ties. Complete Unit Part List:
|
Operating instructions
Instructions for Operation:
1. Remove cover and attach unit to wall using hardware provided.
2. Select metering tip (see section on metering tip selection) and press firmly into check valve provided at the side of the eductor. Install chemical inlet tube on hose barb. The strainer end of the suction tube can be dropped directly into the concentrate container. Replace cover.
3. Connect water inlet hose with 3/4" male garden thread to female swivel at left side of unit. Tighten to avoid leaking.
4. Connect discharge hose to male 3/4" discharge provided at bottom of unit. Using 1/2" or 3/4" bracket and screws provided, secure discharge hose to wall about 12" below unit. This will help to prevent stress on the discharge fitting when tugging on the hose occurs. Hose of 1/2" ID is recommended if the hose length will be 25 feet or less. 3/4" ID hose may be needed if the total length of the hose will exceed 25 feet. Attach appropriate spraying or foaming gun (and ball valve or quick connect) to end of discharge hose.
5. Turn on water supply to unit. Minimum 25 PSI water pressure is required to operate the unit.
6. Turn on product valve to begin proportioning and dispensing. Slide selector switch to either side for product dispensing. Center position provides full volume rinse.
1. Remove cover and attach unit to wall using hardware provided.
2. Select metering tip (see section on metering tip selection) and press firmly into check valve provided at the side of the eductor. Install chemical inlet tube on hose barb. The strainer end of the suction tube can be dropped directly into the concentrate container. Replace cover.
3. Connect water inlet hose with 3/4" male garden thread to female swivel at left side of unit. Tighten to avoid leaking.
4. Connect discharge hose to male 3/4" discharge provided at bottom of unit. Using 1/2" or 3/4" bracket and screws provided, secure discharge hose to wall about 12" below unit. This will help to prevent stress on the discharge fitting when tugging on the hose occurs. Hose of 1/2" ID is recommended if the hose length will be 25 feet or less. 3/4" ID hose may be needed if the total length of the hose will exceed 25 feet. Attach appropriate spraying or foaming gun (and ball valve or quick connect) to end of discharge hose.
5. Turn on water supply to unit. Minimum 25 PSI water pressure is required to operate the unit.
6. Turn on product valve to begin proportioning and dispensing. Slide selector switch to either side for product dispensing. Center position provides full volume rinse.
Amazing yields and costs:
|
|